Recent content by blasterguy15

well the mods are yoshimura trs 3 mil hot rods crank and 13:5:1 compression je piston and thats it

alright thanks i didnt know if i had to do something else since its a 4 stroke and im not that good with these bikes yet now that this ones done its on to my 125

i got this bike running today and it sounds fine it shifts through all the gears i just wanted to know what is a good way to break this bike in we only fired it up on the stands so it doesnt have five minutes on the brand new motor so what are the best ways to break it in??

ya ive been telling my dad to do that he just says that if it ran before it can run again like it is but a guy that he works with drag races bikes and he is gonna do it for him the bike is almost ready to run all i need to do is put oil in it wire it and start it

i would hate to see his house!!

alright so my dad got this 2006 yfz 450 and it blew up in 2 rides well the crank seized up and now we rebuilt it and it got rebuilt with a 3 mil crank and a 13:5:1 compression je piston should we be running race fuel? or can we mix 91 and race fuel?:-/

well its going to get a new clutch basket and ill just buy the tool cause the motor is out of the bike im taking the crank out to get it rebuilt

does anyone know how to remove the clutch i put an im pact to it and all it does is spin the hub is there a good way to take it off without buying a clutch removal tool?? and thanks in advance

clear actually does well on bare metal my dad built his chopper and the rear fender is bare metal with clear it actually looks reallt good

its been done on this forum with a blaster i think its on the engine mods and swaps section its actually pretty intresting

thank you so much that was alot of help

i have a kx125 and it blew up in the first four days i had it and now im rebuilding the bottom end and i was wandering does any one know where i could get a good manual to tear apart the hole motor. and by the way the reason it blew up was because of an air leak the piston was put in backwards...

and before painting use a quality prep solvent to wipe any dust or anything that will flake the paint off you can get prep solvent at your local parts store

rock crawling and building drag boats

well ya but in a really small town like the one i live in u never get deals like this